Send request
Case study5 June 2026Offshore, Norway

Improved well log achieved by placing magnet in front of logging tool

A Magnetic Drift® with brush was run below the logging tool, in order to clean the well for magnetic swarf

Challenge

  • Magnetic swarf interferes with the logging tool
  • Complicates the operation

Solution

  • Installed a MD 5500 magnet which includes a brush beneath the logging tool

Benefit

  • The MD 5500 recovered most of the magnetic swarf downhole
  • Prevented interference with the logging tool
  • Reduced rig time

Introduction

Understanding well integrity is important to make critical decisions during drilling and completion operations. By examining the bond between the casing and the cement pumped into the wellbore annulus, we are able to determine if remedial work is required before completing the well. Such information can be obtained by running cement bond logging tools. In this particular case Baker Hughes was going to run their Integrity eXplorer™, a cement bond logging tool, to evaluate an injector well.

Improved well log achieved by placing magnet in front of logging tool

Challenge

The Baker Hughes Integrity eXplorer™ logging tool uses patented electromagnetic-acoustic transducers capable of measuring the cement bond in any wellbore fluid environment. However, previous experiences with the tool have revealed that it collects a lot of magnetic swarf. The magnetic swarf has also influenced the set-up of the tool, which makes the operator use more time than necessary on this operation.

Improved well log achieved by placing magnet in front of logging tool

Benefit

By applying the MD 5500 magnet in front of the logging tool, the Innovar magnet was able to secure most of the magnetic swarf, keeping the swarf attached to the Integrity eXplorer™ to a bare minimum. This resultet in reduced time on tool set up and therefore, reduced rig time.

Improved well log achieved by placing magnet in front of logging tool

“Innovar supplied a fishing magnet and retrieved all junk from the well on the first attempt. With our conventional tools and methods, this would have taken more time and taken several attempts. This saved us money by avoiding lost production. Thank you Innovar.”

Jan Rømo, Project leader | Entreprenørservice AS

Questions about this job?

Tell us what is stuck in your well and we will tell you what we can do.